1. Clean floor.
2. Pour floor renew directly onto floor.
3. Apply with clean sponge mop or lambswool applicator in moderate coats over entire floor surface (do not work into floor).
4. Allow to dry for 30-45 minutes. A single coat is usually adequate, however, a second coat may be used.
Use on floors only when the product and room temperature are 50° F or higher.
What Surfaces Can be Cleaned With It?
Sealed wood, vinyl, linoleum, no-wax rubber sealed cork, terrazzo, concrete, marble and slate floors.
Care: To maintain, use a damp mop to cleanse floor with mild dish detergent and warm water.
Water Spots: While Floor Renew will add a shine to water spotted areas, it will not remove the spots. Sanding is often necessary to remove water spots. In some cases, re-staining is necessary too.
Notes: This is not meant for outdoor use. It will not be able to provide enough protection from the elements. This product is not a floor cleaner; it must be applied as carefully as a floor finish. It is a good idea to spot check a small inconspicuous area before using on the entire floor.
Cautions: Never apply any other floor finish type product over this product. Irritating to eyes and skin, avoid inhalation. 32 oz.
Bottle renews 625 square feet